Handheld ECU Programmer , DS17 Tricore Boot Reader

DS17 Tricore Boot Reader

DS17 Tricore Boot Reader Description:

1.Commonly named as bootmode this port is the pendent to the Motorola/Freescale BDM port. In contrast to the BDM port, whose pins only have this purpose, the bootmode is done over one of the CAN busses of the processor.

2.The new assembled ECUs are programmed over this port, so Bosch has put it on a 14 pin pad array. It looks like the BDM port but works completely different.

3.To put the processor into the bootmode a modification on the printed circuit board is necessary. This modification depends on the type of the processor and so the type of the ECU. In the most simple case one pin of the processor must be connected to ground. Therefore a contact needle with a wire and a tripod is attached to the system.

4.The power is also supplied over the probe, but is spite to the BDM system the voltage is not manually switchable but automatically controlled by the DS17.

DS17 Tricore Boot Reader Support:

EDC17/MED17/ME17/MEV17/MEVD17/PCF2.1/SD13/SD14/SD16/SID208/SID807